Activation / deactivation of the odometer filter:
After installation, the turn signal must be briefly pressed once, then the module can be activated using the key combination of Mode 1.
Mode 1
Simultaneously press the return button ↩️ on the steering wheel and the arrow key to the left ◀️,
the kilometers are not recorded.
The Km / h speedometer always works up to a speed of 20 km / h.
Above 20 km / h the speedometer works for 10 seconds. (Acceleration phase)
After 10 seconds, the Km / h speedometer stops and drops to zero.
If you come to a standstill or a speed below 20 km / h, the correct speed will be displayed again for 10 seconds.
✅ The head up display always shows the actual speed ✅
Mode 2
If you simultaneously press the return button ↩️ on the steering wheel and the OK button ,
Only half of the kilometers driven will be recorded. (50%)
The tachometer in this mode works continuously but displays half the actual speed.
✅ The head up display always shows the actual speed ✅
Mode normal
Simultaneously b the return button ↩️ on the steering wheel and the button to the right ▶️,
The kilometers are recorded completely and everything works as usual.
The module saves the setting automatically and does not require any additional activation after rebooting.
Each mode can be activated or deactivated at any time, both while driving and while stationary.
The speed display always works in Head Up Display, even with the active module.
Temp The cruise control and lane departure warning also works in the activated state
Plug & Play simplified plug-in system. This makes it possible to clamp the speedometer stopper as fast as possible. Without screwing, soldering or cutting cables
No soldering or cutting of cables and electronic components required. This saves a lot of time because many car owners are always reluctant to cut or solder something on their vehicle. Our connector system is therefore very innovative and saves the Rumknipserei with the scissors
No error messages in the speedometer or the navigation. The speedometer filter is a Plug & Play module which is connected between the speedometer and the control unit. This module has all the necessary cable strands your vehicle needs to process. The module suppresses only the signal of the kilometer count and nothing else. Thus, the danger of an error occurring or being displayed remains practically at 0%
The installation of the module is fairly simple. You just have to get behind the clock. The way to get there is difficult, but is fast. Once you have reached this point, you should pull out the cable that is in the speedometer out and the speedometer stopper / kilometer filter module between the cable, which was previously in the speedometer and stuck the speedometer. More info can be found in the video above!
The speedometer / tacho filter always saves the last adjusted setting. This does not have to be reactivated every time you start your journey. Depending on the state of the module, it is either active or deactivated
