SEAT ATECA – SEAT ATECA CUPRA –SEAT ATECA FR
The module is suitable for all Seat Ateca models!

Known as: Trip Odometer – Mileage Stopper – Odometer Correction Tool – Odometer stopper – Can Blocker – Mileage Stopping – Odometer Rollback – Odometer Adjustment – Odometer Blocker – Can Filter – Speedometer Calibration Tool

SPECIAL FEAUTES OF OUR MODULES:
🔹 ​​The speed display always works, even with the active module. This has the special advantage that all assistance systems in the car function flawlessly. Because without a speed display, the board computer thinks that you are standing and thus does not unlock the assistance systems 🔹

🔸 Temp The cruise control and lane departure warning also works in the activated state, as well as all other assistance systems also work 🔸

🔹 Plug & Play simplified plug-in system. This makes it possible to clamp the speedometer stopper as fast as possible. Without screwing, soldering or cutting cables 🔹

🔸 No soldering or cutting of cables and electronic components required. This saves a lot of time because many car owners are always reluctant to cut or solder something on their vehicle. Our connector system is therefore very innovative and saves the rumknipserei with the scissors 🔸

🔹 No error messages in the speedometer or the navigation. The speedometer Calibration Tool is a Plug & Play module which is connected between the speedometer and the control unit. This module has all the necessary cable strands your vehicle needs to process. The module suppresses only the signal of the kilometer count and nothing else. Thus, the danger of an error occurring or being displayed remains practically at 0% 🔹

🔸 The installation of the module is fairly simple. You just have to get behind the clock. The way to get there is difficult, but is fast. Once you have reached this point, you should pull out the cable that is in the speedometer out and the Speedometer Stopper / Can Filter module between the cable, which was previously in the speedometer and stuck the speedometer. More info can be found in the video above! 🔸

🔹 ​​The Speedometer  Stopper / Tacho filter always saves the last adjusted setting. This does not have to be reactivated every time you start your journey. Depending on the state of the module, it is either active or deactivated 🔹

ACTIVATION AND DEACTIVATION OF THE SPEEDOMETER MODULE:
The speedometer Calibration Tool can be activated from the steering wheel. On the right side of the steering wheel is the 🆗 button. If you keep the 🆗 button pressed for 7 seconds , the activation signal at the hazard warning lights will turn on twice . Then press ⇒ OK button for 7 seconds → Mode 1. Ok – Press button for 7 seconds → Mode 2

If there is no multifunction steering wheel , activation takes place via the windscreen wiper lever 3x Press → Mode 1.Windscreen wiper lever 3x down → Mode 2

Function mode Mode 1: The actual speed is displayed permanently – only 10% of the actual distance traveled is counted. From 100 km only 10km counted.

Mode 2: The actual speed is displayed permanently – only 30% of the actually driven distance is counted. 100/30

Mode 3: Everything in original condition

❗️ In each mode, all assistance systems function properly ❗️

The device can be deactivated just like the activation by pressing the 🆗 button for 7 seconds.

Are you looking for a module for another vehicle? Then press here: 🌐

S u p e r kilometer filter

⚠️ Attention! This device is appropriate only for testing and tuning purposes. However, not for the public traffic.
Similarly, the Speedometer Calibration Tool is not suitable for fraudulent purposes ⚠️